B10-AL 496 Fuel Tank Filter Assembly, Gasoline and Diesel Water Separate 30 Micron Max 25 Gpm 150 Psi, Diesel Tank Water Separator with 1" Npt Top Cap

Features:Replace Parts Number: B10-AL fuel tank filter ; 496 fuel water separatorFuel Filter Element: 30 Microns with Protective SheetHeight: 9.5”Inlet/Outlet Size: 1” NPTFlow Rate: Max 25 GpmWorking Pressure: Up to 150 PsiGravity Flow Rate: Approximately 5 GpmInstallation Tips:1.Always recycle the used filter, DO NOT reuse.2.Attach filter top cap to storage tank valve on opening marked “IN”.3.Attach hose and nozzle to filter opening marked “OUT”.4.When installing the element and bowl, apply a coating of oil to each side of gasket.5.After installing a new filter, prime and start the engine and wait for a few minutes, then check for leaks.6.Plug-and-play, direct fit, easy installation.NOTE:Not Included Installation Guide or Manual, Professional installation is recommended.Please make sure to match with your vehicle before buying.

• REPLACE NUMBER: Fuel tank filter assembly with thread tape replace B10-AL 496. Fuel tank filter with 1" NPT pipe fittings inlet and outlet marked at the top of the cap.
• FEATURE: The fuel filter assembly has a maximum flow rate of 25 gpm, with an operating pressure of up to 150 psi and a gravity flow rate of approximately 5 gpm.
• APPLICABILITY: Use with gasoline diesel or 20% biodiesel (B20) fuel. 30 microns, provide high flow rates and superior filtration efficiency, protect fuels from particles such as rust, sand, dirt and water.
• HYALINE BOWL: Use 495-4 fuel tank filter bowl, makes it easy to visual monitor the fuel flow, the fuel flow will slow down when you need to replace the element. Drain valve installed at the bottom to drain water.
• EASY INSTALLATION: Move the old fuel container under the machine filter, and remove the old filter element and replace with new filter element. Be careful not to let waste fuel contaminate the interior of the machine.